Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
The Only Primer on Modern Sex Dolls- What to Expect
#1
[center][Image: nfaoxus406adxw2wnv657-1.jpg][/center]

[center]CLICK FOR THE BEST SEX DOLL BEGINNER GUIDE HERE[/center]

A Beginner's Guide To Using A Sex Doll: What To Know Before You Start
So you've purchased your first doll, or you're on the point of doing so. Virtually all new owners hit a moment of brief panic at certain point: a 35 kg silicone human unboxed on the living space floor, and you standing there thinking now what? That question is precisely what this guide answers. You will not find fluff or presumptions that you have done this before here, just everyday guidance on what you will genuinely need in your first week and how to steer obvious of costly slip-ups in your first month. A second read after she arrives will make much more sense than the first, so go through it once in advance and once after, when you will catch things you skipped over the first time.

Before you so much as open the package, several things are worth doing, since once she's out of the box, getting her around becomes considerably harder. "Somewhere in the bedroom" isn't an answer, so pick a real area: a wardrobe, a corner, or a storage box. Dolls are weighty and unwieldy, and you do not wish to be improvising storage at 11 at night with an undressed doll in your arms. Evident the space she'll rest on, be it a bed, floor, or storage package, and verify it is clean and free of anything that could transfer dye, as deep-coloured blankets, low-quality fabrics, and anything that might shed colour pose a risk. On carpet, lay something smooth under her. If you've got a low bed, verify it isn't going to sag under her pressure in time.

Get your supplies to hand before she arrives:
1. Cornstarch or baby powder (for TPE dolls)
2. A blow-dryer (for limbering up joints)
3. A clean, pale cloth (for the cloth check)
4. A wide-toothed wig comb (not a standard hairbrush)
5. Drying sticks (for the orifices)
6. Mineral oil formulated for TPE (where relevant)
7. A soft cosmetic brush (for powdering)

None of this is costly, but all of it matters. Everything in the kit will run you maybe £20 and it is the variation among a doll that stays in good condition and one that does not. Go attentively opening the package as opposed to tearing into it, and if it is damaged, picture it first, seeing as that is your only safeguard for a warranty case. A quick inspection comes next: inspect for rips in the armpits and groin, verify all fingers are undamaged, and verify the head sculpt matches the order you placed. If something's wrong, image it without delay and get in touch with the supplier before you do anything else, since a claim gets much harder once the doll has been used or repositioned.

After that comes the aspect that catches virtually every new buyer off guard: she will feel rigid. The joints are tight from the factory, which is totally regular and does not mean anything is broken. The joints need freeing up before you can pose her, and the technique is easy. Soften the TPE around every joint with a blow-dryer on a medium setting, not hot, after that steadily move each joint through its whole range of motion, working through the neck, shoulders, elbows, wrists, hips, knees, and ankles. If a joint will not move, warm it more, and never force anything. Give this an entire hour. It sounds excessive, but it is the variation among a doll you will genuinely pose and a doll that ends up locked in one pose because you gave up.

Everyone is surprised by how hefty she is compared with how she looks. A 35 kg doll does not seem like much right until you lift her from a low position and the load is concentrated in the wrong places, so use good lifting technique, squatting down and lifting with your legs as opposed to your back. Hug her where possible, gripping under the armpits and keeping her close to your body, since the closer she is to your centre of balance, the less pressure you will feel. TPE and silicone both hold body warmth pretty well, so she's warmer than you anticipate, and the first time you contact her attentively she'll feel less plastic than you were probably expecting. That is the biggest reason people call their dolls lifelike, not since of movement or AI, but seeing as the cloth truly reacts to touch in a manner that startles you.

You have to powder her on a regular basis, as TPE gets sticky with time, especially in high temperatures or after cleansing, and a thin layer of cornstarch or baby powder applied with a soft cosmetic brush maintains the exterior smooth and free of dust, so do this at the end of every cleansing session. You'll also need to oil her periodically, as TPE sheds oil with time and needs replenishment, and a thin coat of mineral oil formulated especially for TPE dolls every three months or so keeps the cloth soft and prevents splitting, though don't use too much as too much oil makes the finish oily and picks up collect dust sooner than dried-out skin does.

Cleansing is a process rather than a one-off. After use:
1. Remove any inserts and wash them separately
2. Clean the cavities with warm water and gentle cleanser
3. Dry everything well with drying sticks (fifteen to twenty minutes)
4. Powder the exterior with cornstarch or baby powder
5. Put away her the right way

Do not treat this as optional, seeing as if you skip it you will get mould forming inside her in a few weeks. Many people anticipate it to be quicker, but the entire regime takes just about 45 minutes, and that is the key reason old hands switch to swappable inserts, which cut that time approximately in half.

Novice owners make their biggest slip-up here, as they do not think about storage until it is an issue. Most seasoned owners hang their dolls, using a heavy-duty ceiling mount rated for at least 60 kg with a dedicated loop, which maintains her in the same position without putting stress on the joints. You can put away her lying down as well, but take attention: flat surfaces are fine and uneven ones aren't, and long stretches on her back can flatten the buttocks or breasts, so change the position now and then. UV damages both TPE and silicone and bleaches wigs and coloured parts fast, so never leave her in strong sunlight, and keep her in a wardrobe or a covered carry case.

Most of the many opinions the internet has about owning dolls are mistaken or exaggerated. She's not made of glass, so there's no need to be "careful" in the sense of fussing over her: yes, she's hefty and her joints need attention, but she's also designed to be used. Embarrassment isn't needed, as huge numbers of people own sex dolls, the market has expanded tremendously in the past ten years, and the shame has faded quickly, which makes owning one a personal decision and not a moral failing.

You don't need to treat her like a person either. Certain owners build detailed characters and personalities for their dolls, which is great and component of the appeal for many people, but you do not have to, and if you just want a doll for bodily pleasure and companionship without the roleplay, that is an entirely valid way to use one. The only thing you truly need to get right is the everyday side, as everything else is individual taste and nobody else has a say on how you use something you bought.

Every owner develops their own procedure, and mine if it helps is easy. Ease the joints prior to every session, not a solid hour from the first time but just five minutes or so to be sure nothing is rigid, and powder following every clean no matter what. Run the cloth check on any new clothes even if you've used the same brand before, keep a replacement wig to hand seeing as synthetic fibre takes longer to dry than you'd expect and you don't would like to be waiting, and put away her correctly every time. None of this is fiddly, it is just the regime that maintains your doll in top condition for many years as opposed to months.

Your first month will teach you most of what you need to know, and the slip-ups you make early tend to be low-cost ones when you're careful. The things that go wrong later are the costly ones, and they practically always stem from something skipped in the early weeks. Think of a joint freed up too aggressively, a material tested on the doll in place of a cloth, or a storage arrangement that looked fine until the load pressed down into it. Slow down at the start and the rest takes maintenance of itself.

You will also need to know what to do when something eventually goes wrong, seeing as it will. A tear in the armpit, a loose joint, a blemish that will not come out. The instinct is to panic and assume the doll is wrecked, but practically everything short of a broken skeleton is fixable if you notice it early. TPE mending kits cost very little and handle tiny splits. You can tighten or replace loose joints. The one thing that doesn't come out is dye marks, which explains why the cloth test makes such a difference. Find out which difficulties are fixable and stop worrying about the ones that aren't.

A doll is a significant investment and it deserves careful handling, but "serious" does not mean "difficult." Limber up the joints, powder her often, keep her sensibly, and you will get years out of her, but skip those things and you will be replacing her significantly sooner than you expected. The opening week is the hardest element, and after that it becomes routine. More info at this rosslink. Also check out top article for more.
[center][Image: lwje3h40r9td4hani42wf.jpg][/center]

[center]CHECK OUT THE BEST SEX DOLL GUIDE ONLINE[/center]
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)